hardware:venta_connected
Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Beide Seiten der vorigen RevisionVorhergehende Überarbeitung | Nächste ÜberarbeitungBeide Seiten der Revision | ||
hardware:venta_connected [2018/10/14 02:01] – reinhold | hardware:venta_connected [2018/10/14 02:09] – reinhold | ||
---|---|---|---|
Zeile 6: | Zeile 6: | ||
{{ : | {{ : | ||
- | Now, since I have ZigBee temperature and humidity sensors in every room, I wanted to automate the humidifier and write rules in OpenHAB that would turn on the humidifier whenever the humidity falls below a threshold and also turn it off again once an acceptable level is reached. | + | Since I have ZigBee temperature and humidity sensors in every room, I wanted to automate the humidifier and write rules in OpenHAB that would turn on the humidifier whenever the humidity falls below a threshold and also turn it off again once an acceptable level is reached. |
===== 2. Investigating the electronics of the LW45 ===== | ===== 2. Investigating the electronics of the LW45 ===== | ||
Zeile 254: | Zeile 254: | ||
* Board (NOT tested, routing also not optimized): {{ : | * Board (NOT tested, routing also not optimized): {{ : | ||
* MySensors arduino sketch: {{ : | * MySensors arduino sketch: {{ : | ||
- | * Pictures: {{ : | + | * Pictures: {{: |
- | | + | (In the last picture one can see the error LED dimly lit, which is caused by the use of a voltage divider rather than the LM339/393 comparator...) |
hardware/venta_connected.txt · Zuletzt geändert: 2018/10/28 20:37 von reinhold